| Pattern
Notes:
~~Worked as a flat panel
~~When CO (casting on) stitches, use the e-wrap to cast on the
desired number of stitches.
~~Knit stitch is not the e-wrap. You may substitute with the Flat
Stitch. Pattern has not been tested with the e-wrap.

CO 12sts
Row 1, 3, 5, 7, 9: k
Row 2, 4, 6, 8, 10: p
Row 11: CO 5 at beginning of row. Knit to the end (17sts on loom)
Row 12: CO 5 at beginning of row. Purl to the end (22sts on loom)
Row 13, 15, 17, 19: k
Row 14, 16, 18, 20: p
Row 21: BO 5 at beginning of row. Knit to the end (17sts remain
on loom)
Row 22: BO 5 at beginning of row. Knit to the end (12sts remain
on loom)
Row 23, 25, 27, 29, 31: k
Row 24, 26, 28, 30, 32: p
Bind off with Basic Bind off method.
Finishing: Seam each of the short sides to
each other as diagram shows.

Felt and block dry.
Felting Instructions
- Set washer (top loader) to hot water,
small load.
- Place 1tbs of Eucalan Wool Wash or 1tbs
of Baby Shampoo
- Place item inside a zippered pillow case.
Place the pillow case in the washer along with 2 jeans to aid
in agitation.
- Let the cycle run for about 10minutes
and check progress of box, if the box is not desired size, place
it inside the pillow case again and let it wash for a few more
minutes.
- When the item reaches desired effect/size,
take it out, shape it (you may put something inside to help
in obtaining desired shape). Allow to air dry, about 24-48 hours.
|
| About Designer:
Isela Phelps resides in Cache Valley, Utah
with her husband Sam and her children Bryant and Nyah. In her
spare time, she enjoys cycling, running, swimming and of course
playing with yarn and her looms. You can read more about her adventures
in yarn and life at The
Purling Sprite blog.
Contact Isela.
© Copyright 2008, Isela Phelps |